Cub Cadet 1782 Owner's Manual page 13

A WARNING
To avoid burns from hot engine or muffler,
remove side panels only when engine is
cold.
To remove either right or left side panel, proceed as
follows:
1. Engage the single pedal brake lock. Raise the
hood. Refer to Figure 14 and at top rear of side
panel remove wing nut and flat washer.
2. Loosen LEFT front side panel by applying pres¬
sure to side of grille and gently pulling on side
panel until the snaps pop out of grille side flange.
(See Figure 15.)
NOTE
Be sure both top and bottom snaps have
popped out.
NOTE: LEFT SIDE PANEL SHOWN
Figure 14
1. Wing Nut 3. Side Panel
2. Flat Washer
LEFT SIDE PANEL
3. Loosen RIGHT front side panel by first popping
the top snap out of the grille side flange. Then
grasp front of panel below muffler and pull gently
to remove bottom snap. (See Figure 16.)
SIDE PANEL
RIGHT SIDE PANEL
Figure 16
4. Locate the lock tab and dash panel lock in Figure
17.
Snap
Figure 15
3. Side Panel
1. Side Panel
Figure 17
3. Dash Panel Lock
Grille
4. Grille Side Flange
2. Lock Tab
13