Kenwood DP-3010 Service Manual page 6

DP-3010
DISASSEMBLY FOR REPAIR
SINGAPORE MADE
3. Removing the Pickup
* Remove the tray.
1. Remove the two screws (Od) and remove the catch
of the clamper.
2. Remove one screw and take out the gear 2) ).
3. Remove the two shaft clamper 3) ).
4. Remove the pickup in the direction of the arrow iO ys
Note 1: When installing the pickup :
© Install the pickup so that the metal fittings are engaged
with the guide of the pickup ( ©).
© Keep the flat cable from the pickup away from the
unit as far as possible (@).
Note 2 : When the pickup has been replaced :
© For the protection of the laser diode (LD), the LD
short land of the pickup may be shorted. If so, after
connecting the connector, unsolder the short land (@}.
Lid
Q
=
=
Lu
c
=)
o
—<
o
=
7)
10 Wire clamper