Table of Contents
Advertisement
Select from [Windows Default Themes] for the theme.
For Windows 10
Select [100%], [125%], or [150%].
Select from [Windows Default Themes] for the theme.
Installing the Software
Notes
• If the older version of Wireless Studio is already
installed in the PC, uninstall it (see page 9).
• Quit all applications before installing the software.
• Be sure to log in as the administrator.
Notes on installation
The installation procedure below describes the operation
on the PC that runs Windows 7. Note that the procedure
may vary according to the operating system.
1
Insert the Wireless Studio CD-ROM in your CD-ROM
drive.
2
Click [Start] and then click [Run].
3
Click [Browse] and then select the CD-ROM drive.
4
Select "setup.exe" and click [Open].
The [Welcome to the InstallShield Wizard for
Wireless Studio] screen appears.
5
Click [Next].
The "Choose an area" message appears.
If Wireless Studio is already installed, the "Program
Already Installed" message appears. When this
message appears, select [Repair] to overwrite the
installation, or select [Remove] to first uninstall the
software, and then perform step 4 again.
6
Select your region and click [Next].
7
Verify and if necessary, change the location where the
software is installed.
To change the location, click [Change...] and change
the location where the software is installed.
8
Click [Next].
9
Click [Install].
Installation starts.
When all application files have been copied to the PC,
the "InstallShield Wizard Completed" message
appears.
10
Click [Finish].
8
Advertisement
Table of Contents
