Table of Contents
Advertisement
©
Remove the cover (chapter 16).
©
Remove
the cover plate and
operating
panel
(chapter
18).
©
Pull the 12-channel plug (1) out of the connection strip
X101
on the control board.
©
Remove the two screws (2) in the board.
© = Slide the control board (3) upwards to remove
Installation of a new control board is in reverse order. Please
note the following :
© © [o ensure good heat dissipation, heat conducting paste
(4) must be applied thinly to the back of the board at the
bottom.
©
Great care must be taken when replacing the screws (2),
in order to avoid damaging the new board.
©
Remove the cover (chapter 16).
©
Remove
the
four
screws
(1) in the
cover
plate. (2).
©
Disconnect the battery cable plug connec-
tion (3) before removing the cover plate.
©
Pull
the
12-channel
plug
(4)
out
of
the
connection strip X101 on the control board
Remove wires (5) and (6) from the 12-channel plug (4).
Unscrew the union nut (7).
Remove the cable (8), together with the screw fitting,
from the casing.
-14-
Advertisement
Table of Contents
