Table of Contents
Advertisement
en-us Basic Operation
Press the required program.
1.
→ "Programs", Page 20
a The display shows the program settings.
If required, adjust the program settings. → Page 24
2.
Setting additional programs
Requirement: Home Connect® is set up.
→ "Setting up Home Connect®", Page 26
Set the App Programs program.
1.
Remote Start flashes.
Press Remote Start.
2.
The Home Connect® app displays the programs that
can be selected.
Set a program in the Home Connect® app.
3.
If required, adjust the program settings.
4.
→ "Changing the program settings", Page 24
Start the program.
5.
→ "Starting the program", Page 25
13.3 Changing the program settings
Requirement: A program is set.
→ "Setting a program", Page 23
Adjust the program settings.
▶
→ "Buttons", Page 18
Observe the information about operating logic
→ Page 14 .
Note: The program settings are not saved permanently for
the program.
13.4 Saving the program settings
You can save your individual program settings as
favorites.
Requirements
¡ A program has been set.
→ "Setting a program", Page 23
¡ The program settings have been adjusted.
→ "Changing the program settings", Page 24
Press and hold Favorite for approximately 3 seconds.
▶
24
Press Favorite to call up the saved program.
Note: To overwrite the saved program, repeat the steps
above.
13.5 Loading laundry
Note: To prevent creasing, note the maximum load for the
programs.
→ "Programs", Page 20
Requirements
¡ The laundry is prepared and sorted.
→ "Laundry", Page 23
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry trapped in the door.
13.6 Inserting the measuring aid
Pull out the detergent drawer.
1.
Press down on the insert and remove the detergent
2.
drawer.
Insert the measuring aid.
3.
Advertisement
Table of Contents
