Yamaha AG200FEE 2014 Owner's Manual page 68

PERIODIC MAINTENANCE AND ADJUSTMENT
6. Loosen the axle nut.
1
7. Lift the front wheel off the ground
according to the procedure in the
2
previous section "Supporting the
motorcycle".
8. Remove the axle nut, pull the
3
wheel axle out, and then remove
the wheel.
4
To install the front wheel
1. Install the brake shoe plate into the
5
wheel hub as shown.
6
7
8
9
2. Lift the wheel up between the fork
10
legs.
TIP
11
Make sure that the slot in the brake
shoe plate fits over the retainer on the
12
fork leg.
2
1
1. Brake shoe plate
2. Slot
3. Retainer
3. Insert the wheel axle from the right
hand side, and then install the axle
nut.
4. Lower the front wheel so that it is
on the ground.
5. Connect the brake cable at the
brake shoe plate and then at the
handlebar lever holder.
6. Connect the speedometer cable
and install the clip.
7. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
39 Nm (3.9 m·kgf, 28 ft·lbf)
7-33
8. Adjust the brake lever free play.
(See page 7-18.)
9. Slide the rubber cover back to its
3
original position.