PERIODIC MAINTENANCE AND ADJUSTMENT
7. Check the O-rings for damage and
1
replace them if necessary.
8. Clean the oil filter element with sol-
2
vent, and then install it.
TIP
3
Check the oil filter element for damage
and replace it if necessary.
4
9. Install the oil filter element cover by
installing the bolts and the drain
5
bolt, then tightening them to the
specified torques.
6
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
7
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
8
TIP
Make sure that the O-rings are properly
9
seated.
10. Clean the oil strainer with solvent,
10
and then check it for damage and
replace it if necessary.
11
11. Install the oil strainer, compression
spring, a new O-ring and engine oil
12
drain bolt, and then tighten the
drain bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
12. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter element removal:
1.00 L (1.06 US qt, 0.88 Imp.qt)
With oil filter element removal:
1.10 L (1.16 US qt, 0.97 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
7-11
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11621