Yamaha AG200FEM 2021 Owner's Manual page 67

2. Loosen the locknut at the brake
shoe plate and the brake lever free
play adjusting nut.
1
2
1. Brake lever free play adjusting nut
2. Locknut
3. Slide the rubber cover back.
4. Loosen the locknut at the brake le-
ver, and then fully turn the brake
lever free play adjusting bolt in di-
rection (a).
Periodic maintenance and adjustment
3
2
(a)
1
1. Rubber cover
2. Brake lever free play adjusting bolt
3. Locknut
5. Disconnect the brake cable from
the front brake lever, then from the
brake camshaft lever.
1
3
2
1. Brake cable
2. Brake camshaft lever
3. Axle nut
7-33
6. Loosen the axle nut.
7. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
8. Remove the axle nut, pull the
wheel axle out, and then remove
the wheel.
To install the front wheel
1. Install the brake shoe plate into the
wheel hub as shown.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
1
2
3
4
5
6
7
8
9
10
11
12