en Troubleshooting
Fault
The appliance is vi-
brating, 'wandering'
and making loud
noises during the spin
cycle.
High spin speed not
reached.
Whooshing, hissing or
sucking noises.
Banging noises, rat-
tling in the drain
pump.
Creasing.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
The laundry is too wet
after the spinning
cycle.
40
Cause and troubleshooting
Appliance is not correctly aligned.
Align the appliance. → Page 15
▶
The appliance feet are not fixed.
Secure the appliance's feet. → Page 15
▶
Transit bolts have not been removed.
Remove the transit bolts. → Page 13
▶
Anti Wrinkle is activated.
Select a programme that is suitable for the type of
▶
fabric. → Page 25
The appliance is using a reduced spin speed to elim-
inate an imbalance.
No action required.
Not a fault. Water is pumped in or detergent solution
is pumped out.
No action required.
A foreign object is in the drain pump.
Clean the drain pump. → Page 34
▶
The selected programme is unsuitable for the type of
fabric.
Set a suitable programme. → Page 25
▶
A high spin speed is selected.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is unsuitable.
Observe the programme's maximum load capacity.
▶
→ Page 25
Prepare the laundry. → Page 29
▶
There is too much detergent or fabric softener in the
detergent drawer.
When dosing, observe the marking in the detergent
▶
drawer.
A low spin speed is selected.
Start the programme.
▶
The next time you run a wash cycle, set a higher
▶
spin speed.
The appliance is using a reduced spin speed to elim-
inate an imbalance.
Redistribute the laundry in the drum.
1.