Advertisement
Installation instructions
Air exhaust
NOTE!
The tumble dryer must only be operated when it
is correctly fi tted with exhaust duct.
Connecting the exhaust duct to the dryer
NOTE!
You will need to purchase a UL-CSA-approved
4" ridged metal exhaust duct. The dryer is
delivered with the stub pipe attached to the rear
exhaust outlet, though the exhaust duct can be
attached to either the left or the right exhaust
outlet.
Asko dryers have a "T-style"
exhaust vent that allows you to
connect the duct on the rear, on
the left, or on the right side
Side Exhaust
Outlet
Stub
The duct must not be assembled with screws
or other fasteners that extend into the duct and
catch lint.
Vent
T-tube
Rear Exhaust
Outlet
Duct
Clamp
(not supplied)
Customer Care Center
1-800-898-1879
www.askona.com
To connect the exhaust duct to the rear
outlet
To connect the exhaust duct to the rear outlet,
follow the steps below:
1. Push the duct onto the stub pipe and secure
it with a clamp
2. With the duct attached, insert the stub pipe
into the hole. It should snap into place.
3. After you push the dryer into place, check for
kinks in the duct.
NOTE!
Excessive duct length and too many bends can
impede drying performance. We recommend
that you cut off any excess exhaust duct and run
the duct with as few bends as possible. Make
any necessary bends as gentle as possible.
NOTE!
Maximum duct length of 60 feet. A maximum of
4 elbows may be used, but 4 feet of duct must
subtracted from the total vent length for every
90° elbow used.
5
Advertisement
