Table of Contents
Advertisement
Playback your Recordings
| Playback
or View on a TV |
Playback or View on a TV
Your Palmcorder may be connected to a
Before you begin...
TV to play back tapes or to view what you
* Connect the Palmcorder to a power source.
are recording.
1 Set the POWER switch to VCR to
C. TV with AUDIO/VIDEO IN Jacks. — )
AUDIO/VIDEO IN Jacks.
playback a tape.
is
Ы
Ог, set to CAMERA to view what your
pa of {|
Palmcorder is recording.
To Audio In |
та
the TV ON and set it to LINE
INPUT.
Check your TV operating instructions
for further information.
Note:
If your TV has no VIDEO or AUDIO IN
Jacks, select CH 3 or 4 on your TV to match
the RF Adaptor CH 3/4 switch and set the
VCR/TV selector on the RF Adaptor to VCR.
Audio/Video
Cable
(Supplied)
uon
215
y"
To Audio/Video Out
З Start playback or begin a recording.
TV without AUDIO/VIDEO IN Jacks.
To Audio
To watch TV only
[Video Out
|
If you have connected the Palmcorder
to your TV using an RF Adaptor:
Set the POWER
switch to OFF on the
Paimcorder.
Then, set the VCR/TV Selector on
the RF Adaptor to TV.
RF Adaptor
(optional)
UHF Antenna
VCR/TV
Selector
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
Advertisement
Table of Contents
