Fault
Appliance does not
start.
Programme starts
automatically.
Appliance stops dur-
ing the programme or
cuts out.
Basic settings cannot
be changed.
Fault
Appliance door can-
not be closed.
Lid on the detergent
dispenser cannot be
closed.
Fault
Filling valves making
knocking noises.
Cause and troubleshooting
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until programme ended.
→ "Terminate programme", Page 32
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
Check whether the rear panel of the appliance is
▶
being pressed in by a socket or hose holder that
has not been removed.
Arrange the tableware so that no parts project bey-
▶
ond the basket and prevent the appliance door
from closing properly.
A programme is currently running. Changing basic
settings is only possible at the start of a programme.
Cause and troubleshooting
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.
Check whether the appliance has been installed
▶
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
Remove detergent residue.
▶
Cause and troubleshooting
Caused by the domestic installation. No appliance
fault present. Does not affect functioning of the appli-
ance.
Can only be remedied in the domestic installation.
▶
Troubleshooting en
47