Table of Contents
Advertisement
Fault
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
Irreversible clouding
of glassware.
Rust spots on cutlery. Cutlery is not sufficiently rust-resistant. Knife blades
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Excessive formation of
foam occurs.
Cause and troubleshooting
Do not place tableware or fragrance dispensers in
2.
the tablet collecting tray.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
Only remove large remnants of food and do not
▶
prerinse tableware.
Glasses are not dishwasher-proof, only suitable for
dishwashers.
Use dishwasher-proof glasses.
▶
Glasses are usually only suitable for use in a dish-
washer, i.e. long-term wear or long-term changes
must be expected.
Avoid a lengthy steam phase (standing time after
▶
wash cycle ends).
Use a programme with a lower temperature.
▶
Set the softening system to the water hardness.
▶
Use detergent with a glass protection component.
▶
are often more severely affected.
Use rust-resistant tableware.
▶
Cutlery may also rust if washed together with rusting
items.
Do not wash rusting items.
▶
Salt content in washing water is too high.
Remove any spilled special salt from the tub.
1.
Screw the cap of the special salt dispenser on tight.
2.
Spray arms were blocked by tableware so detergent
was not rinsed out.
Check that the spray arms are not blocked and can
▶
rotate freely.
Detergent dispenser was damp when detergent was
added.
Only add detergent to a detergent dispenser when
▶
dry.
Hand washing-up liquid is present in dispenser for
rinse aid.
Immediately add rinse aid to the dispenser.
▶
→ "Adding rinse aid", Page 25
Rinse aid has been spilled.
Troubleshooting en
45
Advertisement
Table of Contents
