ã= Safety instructions Warning Knives and other utensils with sharp points Delivery must be placed in the cutlery basket with the points downwards or horizontally on – Check the packaging and dishwasher immediately for damage caused in the knife shelf *. transit.
Damage Getting to know your – The appliance may be repaired and appliance opened up by a technician only. To do this, disconnect the appliance from the Diagrams of the control panel and the power supply. Pull out the mains plug interior of the appliance can be found in or switch off the fuse.
Water hardness table Water softening system Water Hardness mmol/l Set value To ensure good washing results, the hardness range on the dishwasher requires soft water, i.e. value machine containing low amounts of lime, otherwise °Clarke white limescale will be deposited on the 0‒8 soft 0‒1.1...
Switching off salt refill indicator/ Special salt water softening system If the salt refill indicator X is impaired Using special salt (e.g. when using combined detergents Always refill with special salt immediately containing salt component), it can be before switching on the appliance. This switched off.
Setting amount of rinse aid Rinse aid The amount of rinse aid dispensed can be set from : to : . This is the factory As soon as the rinse-aid refill indicator ` setting : is lit on the fascia, there is still a rinse-aid Do not change the amount of rinse aid reserve of 1 –...
Unloading the dishwasher Utensils Hot utensils are sensitive to shock! Therefore, when the programme ends, Not suitable leave the utensils to cool down in the – Cutlery and utensils made of wood. dishwasher until they can be handled. – Delicate decorative glasses, craft and Basket 1B antique utensils.
Folding spikes * Detergent * depending on model The spikes can be folded down to improve You can use tablets as well as powder arrangement of pans, bowls and glasses. or liquid detergents for dishwashers, but never use washing up liquid. The dosage can be individually adjusted with powder or a liquid detergent according to the degree of soiling.
Adding detergent Combination detergent – If the detergent dispenser 1R is still Apart from conventional detergents (Solo), closed, press the lock 1Z to open the a number of products are offered with detergent dispenser. additional functions. These products contain not only the detergent but also Pour detergent into the dry detergent rinse-aid and salt replacement substances dispenser 1R only (insert tablet flat,...
Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Type of utensils Type of soiling Programme Possible additional Programme sequence options Prerinse pots and pans, very adhesive burned- Clean 70°...
Additional options Washing the dishes Programme data * depending on model Additional options can be set with the The programme data (consumption buttons @. values) can be found in the summary of instructions. They refer to normal Ÿ Express Wash * conditions and the water hardness set value : .
Timer programming * Interrupting the programme – Switch off ON/OFF switch (. * depending on model You can delay the start of the programme The LEDs go out. The programme is in 1-hour steps up to 24 hours. saved. – Close the door. If the door was opened on an –...
Intensive drying Maintenance and care The final rinse uses a higher temperature which improves the drying result. The A regular inspection and maintenance of running time may increase slightly. your machine will help to prevent faults. (Caution if utensils are delicate!) This saves time and prevents problems.
Filters Spray arm The filters 1* keep large foreign objects Limescale and dirt from the rinsing water in the rinsing water away from the pump. may block nozzles and the bearing assemblies of the spray arm 1". These foreign objects may occasionally block the filters.
Waste water pump Troubleshooting Large food remnants in the rinsing water not retained by the filters may block the The majority of faults which could occur in waste water pump. The rinsing water is daily operation can be rectified by the then not pumped out and covers the filter.
Refill indicator for salt X and/or rinse- ... on the appliance aid ` is not lit. Spray arm rotates sluggishly. – Refill indicator/s switched off. – Spray arm blocked. – Adequate salt/rinse-aid available. Cover on the detergent dispenser cannot Refill indicator for special salt X is lit. be closed.
White stains on the utensils/glasses Customer service remain milky. If phosphate-free detergents are used with If the advice given does not resolve your hard tap water, white deposits may be problem, please contact your customer deposited more easily on utensils and service.
– Some models: Installation The plastic housing on the water connection contains an electric valve, The dishwasher must be connected the connecting cables are in the supply correctly, otherwise it will not function hose. Do not cut through this hose, properly.
Installation Electrical connection The required installation dimensions can – Connect the appliance to an alternating be found in the installation instructions. current only, ranging from 220 V to Level the appliance. Ensure that the 240 V and 50 Hz or 60 Hz via appliance is situated securely on the floor.
Transportation Waste disposal Empty the dishwasher and secure loose parts. Both the packaging of new appliances and Drain the appliance according to the the old appliances themselves contain following steps: valuable raw materials and recyclable materials. – Turn on the tap. Please dispose of the individual parts –...
Page 23
Childproof lock (door lock) * To open the door, move lever to right and pull door handle. Always close the appliance door completely when you leave the appliance. This is the only way you can protect your children from potential dangers.
Page 24
The tap should only be turned off if you are absent from home for a prolonged period, e.g. several weeks holiday. Siemens-Electrogeräte GmbH Carl-Wery-Straße 34, 81739 München To book an engineer visit and product advice...