Table of Contents
Advertisement
en Troubleshooting
Fault
Display "Check water
supply" flashes
Displays flash
All LEDs lit up or
flashing.
44
Cause and troubleshooting
A technical fault is present.
Press
.
1.
Unplug the appliance or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Insert the mains plug of the appliance in a socket
4.
or switch on the fuse.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press
.
‒
Turn off the water tap.
‒
Pull out the mains plug.
‒
Contact Customer Service → Page 49 and give
‒
the error code.
Appliance door is not closed properly.
Close the appliance door.
▶
Arrange the tableware so that no parts project
‒
beyond the basket and prevent the appliance
door from closing properly.
A software update is possibly installing.
Wait until the software update has been installed.
1.
This process can take approx. 30 minutes.
If the appliance is not ready to use after
2.
30 minutes, perform a reset.
Press the main switch button for approx.
‒
4 seconds.
a Your appliance is resetting.
Electronics have detected a fault.
Press the main switch button for approx.
1.
4 seconds.
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
‒
the fuse box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
‒
mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 49
Advertisement
Table of Contents
