Zenith L15V36 Operating Manual page 18

VCR Connection and Viewing Setup
- In Video mode, TV automatically reverts to TV mode if the fcr button or flashbk buttons are pressed.
- See following pages to connect to other A/V external equipment to input jacks on the TV.
Connecting a VCR
Connecting a VCR
1
Connections
Connect the audio/video output jacks on VCR to the corresponding input jacks on the TV.
1
2 Viewing Setup
Watching TV programs
Turn the TV on and tune to a channel.
-
Watching VCR
a. Use
tv/video
depending on connection setup: 1 or 2.
- Connection 1: Set VCR switch to 3 or 4 and then tune TV to the same channel number.
- Connection 2: Select Video 1 or 2 source input to use Audio/Video In connections.
b. Insert a video tape into the VCR and press the PLAY button.
18
Y P P
ANT IN
B R
+75
COMPONENT(480i/480p/720p/1080i)
DVD/DTV IN
Typical
Antennas
ANT IN
S-VIDEO
ANT OUT
Direct
connection
CH3
button on the remote control to select TV (Ant In.) or Video source,
L R
PC INPUT PC
SOUND
AUDIO
OUT
IN
CH4
(R) AUDIO (L) VIDEO
VCR Connection Panel
VIDEO (MONO) L AUDIO R
VIDEO IN
2
206-3922