Picture/Sound Source Selection - Zenith H27E46DT Installation And Operating Manual, Warranty

Picture/Sound Source Selection

Make connections, use the TV/VCR Source key, or use Channel Up/Down to choose the
available picture and sound sources to appear on the TV screen
1
Front
(Camport)
computer in
2
Front
Computer In
ANTENNA
CABLE
3
Rear
(Ch_ _)
1
Make connections to Front Audio/Video
In or Front Computer In, to use these
Auto Sense sources, disconnect device(s)
when finished.
2
To access other available sources, press
TV/VCR SOURCE repeatedly to show selec-
table sources on the screen. Highlight
the source you want to display, then
press ENTER to change to the source.
Note: The rear Audio/Video In jacks can
be selected by keying in 999 on the
remote number keypad
Auto Sense source connections override all
other sources. The front Video In jack and the
front Computer In connector are Auto Sense
source inputs. If you have device(s) connected
to either of these jacks, you will not be able to
change channels or sources until you have dis-
connected the device(s).
P A G E 2 4
AUX IN R- AUDIO- L
VIDEO
4
Rear
(Aux)
S-VIDEO IN
R- AUDIO- L
5
C
O
M
P
U
T
S-Video
E
R
I
N
Video Out
C
O
M
R- AUDIO- L
P
U
COMPUTER
T
AUDIO
E
R
I
N
6
Rear
Computer
SVGA
Typical Auto Sense Sources available if the Auto Sense feature is on.
1st.
2nd. Front Computer In (ComPort) -No other sources available
Other Selectable Sources if:
3rd.
4th. Aux Video
5th. S-Video
6th. Rear Computer SVGA
Select 3, 4, 5, and 6 using TV/VCR Source, or the Source menu.
Note: Auto Sensing can be disabled and source priority selection can be
TV back
ANTENNA
CABLE
S-VIDEO OUT S-VIDEO IN
R- AUDIO- L
R- AUDIO- L
VIDEO AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L AUDIO
Priority of Source Selection
Front Audio/Video In (CamPort) -No other sources available
1. Front Audio/Video In, is not connected, then.
2. Front Computer In, is not connected, then.
Antenna/Cable
changed in the service menu, see service manual.
206-4543