Table of Contents
Advertisement
Simple Editing
This unit allows the execution of a manual edit when the edit points have not been entered.
In still playback, on the PLAYER and RECORDER, set the points which will be the IN points. When the EDIT key is pressed, the
current position of the tapes will automatically be entered as the IN points and the editing will start.
When the EDIT STOP key is pressed, the current positions of the tape will be entered as the OUT points and the editing will stop.
3899
38 32 |
C1) Set the editing mode.
'
Assemble editing
elnsert editing
C3] Start playback on the PLAYER and search for the position
at which the editing will start and then set the PLAYER to
still playback.
~29-
@ Start playback on the RECORDER and search for the
position at which the editing will start and then set the
RECORDER to still playback.
BS@o
ey
@ Press the EDIT key to start the edit. The EDIT lamp will
light up and the IN points will automatically be entered.
(i)
(7) Stop the edit by pressing the EDIT STOP key at the
desired point while monitoring the picture.
When the EDIT STOP key is pressed, the OUT points will
be entered automatically.
if not desired, press the STOP key.
eal
@ The EDIT lamp will go out and the edit will stop.
Hae
Editing using Two PLAYERs (A/B Roll Editing) — with the switcher
This unit allows the execution of editing with two players, i.e., the ability to pertorm A/B Roll edits.
Connect the two PLAYERs and RECORDER to this unit and use the optional Switcher (AG-SW800). Refer to page 12 for further
details.
eo
a
{ a8
0058
ae
| =e
@ Press the A/BROLL key. The A/B roll editing mode will be
set after the lamp lights up.
®Tocancel this mode, press the A/B ROLL key again. The
lamp will go off.
e
Select the editing mode.
*tnsert editing
© Select the VTR on the player side on which the A roll will
be used.
©The VTR that has been first selected will always be the A
roll side.
The VTR for the B roll side cannot be selected until the
one for the A roll side has been selected.
@ Enter the ed it points on the A roll.
There are three ways to enter these points. These are
using the Mark IN and OUT, numerics, or + and — keys.
Refer to pag e 21.
e
The edit poi nt lamps will light up as shown in the figure
below when the points are entered on the A roll.
When the P1 VTR is the A roll side.
e
Select anoth er VTR on the player side that will be the B roti
side and press the keys.
@ Enter the edit points on the B roll.
There are th ree ways to enter the edit points. These are
using the Mark IN and OUT, numerics, or + and — keys.
Refer to page 21.
e
The edit point lamps will light up as shown in the figure
below when the points are entered on the B roll.
When the P2 VTR is the B roll side.
-~30-
Advertisement
Table of Contents
