Table of Contents
Advertisement
@ TRANSITION TIME DISPLAY
Used to display the transition time in frame units during the
Wipe, Dissolve or DSK mode. Refer to page 41.
@© PATTERN NUMBER
DISPALY
@ AUTO key/lamp
Used to set the edit point entry mode when the AG-SW800
audio/video
switcher
is used
and
the video
picture
is
manually switched using the Take key. Refer to page 51.
@ TRAN key/lamp
Used to set the transition time. Refer to page 41.
© DIS key/lamp
Used to switch the screen using the dissolve effect. After
pressing this key, you can do different kinds of dissolve
effects by specifying the number.
The P IN/OUT point will give a fade in/out effect.
. Refer to page 46.
© WIPE key/lamp
Used
to switch the screen
using the wipe effect. After
pressing this key, you can use different wipe patterns
by
entering the pattern numbers. Refer to page 47.
@ KEY key/lamp
Used to set the down stream keyer effect. Refer to page 48.
@ TAKE key
@ Effect point select key
Used to select the effect points.
@ AUDIO key/lamp
Used to record the audio effect. Release the key to record
the normal video effect. Refer to page 50.
@® LOAD key/lamp
If pressed, the lamp will light up and the edit data will be
entered from the computer through the 25-pin DATA
IN/OUT terminal. Refer to page 65.
@® SAVE key/lamp
If pressed, the lamp will light up and the edit data will be
Output to the computer through the 25-pin DATA IN/OUT
terminal. Refer to page 65.
@ 10 key Numeric Pad
Used to enter the desired numbers of the edit IN/OUT
points, and event after selecting the registering mode.
@ ~ key
@ C (Clear) key
:
Press this key to delete the registered data.
@ ENTER key
Used for executing the entry.
@ TOTAL key
After this key is pressed, the display shows the time from the
start point to the current OUT point of the event on the
RECORDER tape. If no OUT point of the RECORDER
has
been registered, the time to the IN point of the RECORDER
will be shown
on the display. Also, the error code js
displayed on the PLAYER display. (See pages 55 and 72.)
@ A/B ROLL key/lamp
Press this key to set the unit to the A/B mode. In this mode,
two PLAYERs can be used for an edit. When the unit is set to,
the normal mode, this lamp will go out.
® TCG SET key
:
Used to set the TC (time code).
@® DUR (Duration) key
Press this key to check the time length of an edit.
(See page 59.)
@ AUDIO SPLIT key/lamp
Press this key to enter audio edit points only. After these
points have been entered, the lamp goes out and the video
edit points can be entered.
@ ASSEM key/lamp
Press this key to execute assemble editing.
® V, A1, A2, TC keys/lamps
Used in the insert editing mode.
V:
Press to select the video signal.
TC:
Press to select the time code signal.
Note: This key can not be used when a 34-pin I/F
Board has been installed in the RECORDER VTR.
© EDIT POINT Entry lamp
Lights up when an edit point is entered.
(See page 57.)
@ PREVIEW key/lamp
Used to rehearse the editing process.
Advertisement
Table of Contents
