Table of Contents
Advertisement
12.8 The SensiCare System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause
maximum declared load indicator goes off,
the SensiCare System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
Time Manager is available, during this
phase the Time Manager bars
placed below the time digits play a simple
animation. The drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
programme again. The SensiCare phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
button, the
is
button to start the
The SensiCare detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced by means of the Time
Manager button.
The SensiCare System is not available
with all programmes such as :Wool,
Rinse and programmes with short cycles.
12.9 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pause
The washing programme continues.
12.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to activate
the appliance.
If the SensiCare System has completed
and the water filling has already started,
the new programme starts without
repeating the SensiCare System. The
water and the detergent are not drained
out in order to avoid waste. The display
shows the maximum duration of the
programme, updating it about 20 minutes
after the starting of the new programme.
There is also an alternative way of cancelling:
1. Rotate the selector knob to the "Reset"
position
.
2. Wait for 1 second. The display shows
.
Now, you can set a new washing programme.
button.
again.
ENGLISH
25
Advertisement
Table of Contents
