GE Profile PLD617RW Owner's Manual And Installation Instructions page 21

6. REPLACE COOKTOP
Place the cooktop back into position and attach
Phillips screwdriver.
7. TEST COOKTOP BURNERS
Push and turn the appropriate burner control
knob counterclockwise to the HI position until
the burner is lit. If air is in the supply line, it
may take up to a minute for the air to purge
and the burner to light.
Once burner is lit, continue pressing knob for 5
seconds until the flame sensor is heated.
The flame may burn yellow for a few seconds,
then it should turn blue. If the burner continues
to burn mostly or completely yellow, see
technician.
Rotate the burner control knob to LO. Make
sure that the flame completely surrounds the
burner. There should be a flame at the burner
ports and no air gap between the flame and
the burner. If the burner does not meet this
Repeat these steps to test each burner.
49-2001566 Rev. 0
Installation Instructions
8. TEST OVEN BURNER
Pull the oven handle to open the door.
Push and turn the oven control knob
counterclockwise to the
oven control knob pressed until the oven pilot
is lit. If air is in the supply line, it may take up
to a minute for the air to purge and the oven
pilot to light.
Once the pilot is lit, keep the oven control knob
pilot sensor becomes heated.
Release oven control knob and visually confirm
oven pilot remains lit. If oven pilot goes out,
repeat bullets 2 and 3.
Rotate the oven control knob to each
temperature and inspect the burner flame. If
the flame is completely or mostly yellow, see
technician.
9. FLAME QUALITY
The burner flames for the cooktop and bake
burners should be blue with yellow tips. Long,
flames may show signs of an orange tint when
well heated or signs of flickering orange due to
particles in the gas or air.
position. Keep the