GE Profile PLD617RW Owner's Manual And Installation Instructions page 19

1.
Attach the range oven in the cabinet opening
by driving four screws into the countertop.
Install 2 screws per side using preferred hole
options based on countertop construction. If
countertop is wooden, start by drilling pilot
screws into the holes to attach.
2. GAS SUPPLY
WARNING
Fire Hazard: Do not use a
WARNING
Explosion Hazard: Do not
the pressure regulator resulting in fire or
explosion hazard.
WARNING
detected by smell alone. Gas suppliers
recommend your purchase and install an
UL approved gas detector. Install and use
in accordance with the manufacturer's
instructions.
Gas Pressure Regulator
regulator supplied with this range. For proper
operations the inlet pressure to the regulator
should be as follows:
49-2001566 Rev. 0
Installation Instructions
2.
Female connection to the regulator in the upper
right rear corner of the cabinet
Tighten the gas line to the regulator using 2
wrenches.
IMPORTANT:
the gas supply pipe in case of bend or damage
during installation. Make sure the gas supply
pipe cannot contact any moving parts after
installed.
When using pressures greater than ½ psi
valve from the gas supply piping. When using
test the gas supply system, simply isolate the
range from the gas supply system by closing the
individual shut-off valve.
Propane Supply
Line Connection