Cable Service - Zenith H25F36DT Installation And Operating Manual, Warranty

Hook Up Cable (CATV) to the TV
Connect cable service to the TV
1
Locate the Antenna/Cable jack on the back
of the TV.
2
Connect the wire that runs from the wall directly
to this jack, according to one of the diagrams to
the right.
3
Remove the back of the remote and put in
two AA batteries.
4
Plug in the TV. The TV is designed to operate on
normal current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
If you're using a cable box, leave the TV on channel 3
or 4 and use your cable box to change channels.
If you're using a cable box, Auto Program might only
find the channel your cable service is on (usually chan-
nel 3 or 4). Don't worry, that's all you need!
206-3854
Back of
Remote
Cable TV
Wall Jack
Antenna
Round Wire
(75ohm)
Cable TV
Wall Jack
Cable Box
In
output
Out
switch 3 4
RF Coaxial Wire
(75ohm)
TV Back
Matrix
Out
Cable
Video
R- Audio - L
In
In
M.P.I.
S-Video
R- Audio - L
In
In
TV Back
Antenna
Cable
Video
R- Audio - L
In
In
M.P.I.
S-Video
R- Audio - L
In
In
P A G E 7
Matrix
Out