Zenith H25F36DT Installation And Operating Manual, Warranty page 35

Installer menus
Installer Menu Items 14-I through 30-I: Detailed Descriptions
You may opt for TV channels only; TV channels + Off/ON with
these settings for Scan Mode:
Scan mode Characteristics
0 Channel up/down keys change channels only.
1 Channel down below the lowest channel (or
channel up higher than the highest) and TV
turns off.
14-I. STRT CH IN SM
When set to 1, installs TV on/off event below the start channel
at TV turn on.
15-I. SLEEP TIMER
When set to 1, the SLEEP TIMER feature may be used (but no
message is displayed prior to turn-off). When set to 0, the sleep
timer is not available.
16-I. EN. TIMER
Set to 1, timer function is available to user. Set to 0 to disable
Timer functions. (Clock must be set in order to use Timers.)
17-I. ALARM
Gives you the option of making the alarm function available to
the user. Set to 1, alarm function is available to user. Set to 0 to
disable the Alarm function.
Note: Clock must be set in order to set the Alarm.
18-I. NOT USED
19-I. NOT USED
20-I. FEATURE LEVEL
Default set to ZEN 1 for Zenith IR remote control operation.
Set O, P LBL for Zenith Private Label IR remote con-
trol operation. Warning: Do not set to "0" or remote
will not control TV.
Installer should leave item 20-I. FEATURE LEVEL
set to 1 (default).
206-3854
21-I V-CHIP
Set to 1 to activate V-Chip (Parental Control); have it available
to user to filter or control or restrict programming content. Set
to 0 to turn V-Chip feature off, not available to user; no pro-
gramming restrictions can be set.
22-I. MAX BLK HRS
Set to 0 to 99 for the maximum V-Chip (Parental Control) block
hours. Default is 12 blocking hours.
23-I. CAPTION LOCK
Set to 1 to restore previous caption On/Off state after TV turns
off. When set to 0, captions are always off, when TV is initially
turned on.
24-I. TEXT MODE
Determines whether TEXT 1, TEXT 2, TEXT 3, or TEXT 4 decoding
is enabled when TEXT is turned on (either from the Setup Menu
or directly with CC on the remote).
TIP: Set Text Mode to 1 only if text is offered in your video
system.
25-I. FUNCTION PRE.
Set to 0 to suppress CHANNEL PREVIEW from the FUNCTION menu
with some Pay-Per-View systems.
26-I. NOT USED
27-I. NOT USED
28-I. CH. OVERRIDE (Channel Override)
When set to 1, the user can select channels with either Channel
Up/Down or by direct keypad entry. When set to 0, only those
channels that are entered for scanning may be selected by direct
keypad entry. Note: If set to 0, Auto Program is locked; (as
shown on Setup menu) you cannot do a channel search.
29-I. OLD OCV (On Command Video
Set to 1 for operation with systems from On Command
Corporation.
30-I. ACK MASK
M.P.I. Communication Parameter. Leave at default setting unless
changed by Pay-Per-View provider.
TM )
P A G E 3 5