Table of Contents
Advertisement
INSTALLATION
16
NOTE
• The stacking kit should be aligned depending on
the depth of the washing machine. (When you
open the door or look at the side of the washing
machine, you can find the dimension
information of your washing machine at the
label.)
How to align LG stacking kit to the appliance
Type A
550 mm
1
the
*1
depth
1
599 mm
• For Type A, it must be assembled with 550R or
550L on upper part.
• For Type B, it must be assembled with 600R or
600L on upper part.
*1 The depth of the washing machine
1
Place the appliance on the top of an LG front
load washing machine.
2
Remove the 2 screws from the bottom of the
rear cover on each side.
Type B
600 mm
1
the
*1
depth
1
650 mm
3
Align the LG stacking kit holes and the rear
cover holes in a line.
• In case of that the depth of the washing
machine is 550 mm or more and 599 mm or
less
• In case of that the depth of the washing
machine is 600 mm or more and 650 mm or
less
4
Fasten the 2 screws that were removed earlier
from the appliance to the stacking kit.
5
Use the 4 screws in the accessory box (16 mm)
to assemble the washing machine rear cover
and stacking kit.
6
The procedure for the opposite side will be the
same.
Installing the Optional Drain
Hose
Normally, condensed water is pumped up to the
water container where water is collected until
manually emptied. Water can also be drained out
directly to a mains drain, especially when the
appliance is stacked on top of a washing machine.
With the connecting elbow or T piece of the mains
drain hose, simply change the water path and re-
route to the drainage facility as below:
Advertisement
Table of Contents
