Table of Contents
Advertisement
Function
Daisy Chain
Overdrive
DDC-CI
Status LED
Power Button
Factory recall
Fujitsu
Description
Establishing a daisy chain via USB-C
Normal = up to two monitors in total
Advanced = more than four monitors in total
Important note: When changing this function, the power supply via USB-C
will be briefly interrupted!
For the Advanced setting, the speed of data transmission via USB-C is
reduced from USB 3.1 Gen1 (up to 5 Gbit/s) to USB 2.0 (up to 480 Mbit/s).
Important note: Briefly unplug the signal cable if you experience any issues
when changing this setting.
This option only appears if your model supports daisy chain and USB-C
is selected as input signal.
Configuring an increased reaction time
Off = no increase in speed
Normal = recommended increase in speed (~7 ms)
Advanced = maximum increase in speed (~5 ms)
This function can be used to improve the focus in fast moving images.
This setting can only be configured in Video or Custom application mode.
Enable/disable Display Data Channel - Command Interface
This function allows data to be exchanged via the connection between the
PC and the display.
Enable/disable Status LED
With this setting, you can switch the status LED on the monitor on and off.
Setting the function of the On/Off switch
With this setting, you can decide whether to use the On/Off switch on the
monitor to switch the display or the connected computer on and off.
This option only appears if USB-C was selected as an input signal.
Activate the factory settings
With this function all settings are reset to the factory settings.
► Press the
button to run the function.
► Press the
button to confirm or the
The language selection menu appears.
With a VGA data cable, the message Auto Processing is displayed.
button to cancel.
Operation
37
Advertisement
Table of Contents
