Keyboard Cable Replacement - IBM 3101 Maintenance Information

1.
Turn power off
2. Disconnect the Keyboard cable from the Logic Element.
3. Remove the Keyboard Element cover, as described under "Keyboard
Element Cover," and the Keyboard assembly, as described under
"Keyboard Element Keyboard Assembly."
4. Remove the screw and the strain relief from the base assembly.
5. Disconnect the Keyboard cable
assembly.
6. Install in reverse sequence.
connector from the Keyboard
1.
Push the left and right upper corners so that the bottom edge
comes out.,
2. Grasp the left and right bottom edges and pull forward slightly~
3. Grasp both side edges and pull to remove.
4. Insta-1-1 a new filter in the reverse sequence making sure the
protruding edge is at the bottom.
1
: .
•
1.
Hold the knob and-pull it out.
2. Replace with the new knob. -
4-19