Advertisement
Input
CONNECTIONS
Output
DIGITAUMIC/LINE IN
DIGITAL (OPTICAU/IINE OUT
• The DCC170 can be connected to a recording source via a
digital, optical or analog cable.
DIGITAL (COAXIAL/OPTICAL) connection
• Connect the supplied coaxial (SBC 1275) or an optical (SBC
1270) signal lead to the 016ITAL/MIC/L1NE IN socket of
your DCC player and to the corresponding output socket of
the required recording source (e.g. DIG OUT/OPT OUT).
• In case of a digital/optical connection there is no need to
adjust the recording level.
Warnings
-The DCC 170 can not record the digital input when you are
using the rechargeable batteiy. Make sure that during
digital recording the DCC player is being powered via the
mains adapter.
- Make sure to use the SBC 1275 cable for coaxial digital
connection. When using another cable the connection may
network properly.
ANALOG connection
• Connect a signal lead to the DIGITAL/MIC/LINE IN socket
of your DCC 170 and to the corresponding output socket of
the recording source (e.g. LINE OUT).
• The input signal is automatically changed to analog.
• Slide the MIC/LINE switch to the LINE position, set the REC
MODE switch and adjust the recording level, (see also
chapter RECORDING).
DIGITAL (OPTICAL) connection
• For DCC reproduction through a high-quality stereo system
with an optical digital socket, use an optical signal lead to
connect the socket DIGITAL (OPTICAL)/LINE OUT to the
input socket OPTICAL DIGITAL IN of the other set.
ANALOG connection
• For DCC reproduction at home through your stereo system
(amplifier, receiver, recorder, etc.), use the supplied signal
lead to connect the socket DIGITAL (OPTICAL)/LINE OUT to
the input sockets LINE IN, AUX or DCC IN of the other set.
• Adjust the sound with the controls of the stereo system.
The VOLUME control and the DBB selector of the DCC
player do not affect the output signal of the LINE OUT
socket.
UNE IN / AUX / DCC IN / TAPE IN
PHONES/REMOTE_
• When you are using the remote control, connect it to this
socket. The plug of the in-ear phones SBC 3179 can then be
inserted in the PHONES socket of the remote control.
• When you are not using the remote control, you can
connect the in-ear phones directly to the PHONES/REMOTE
socket of the DCC player.
MICROPHONE input
• Connect the microphones to the DIGITAL/MIC/LINE IN
socket of yourDC(i 170.
• The input signal is automatically changed to analog.
• Slide the MIC/LINE switch to the MIC-L or MIC-H position,
set the REC MODE switch and adjust the recording level,
(see also chapter RECORDING).
9
Advertisement
