Advertisement
PLAYBACK
PLAYING A DCCCASSEnE_
• Make sure the HOLD function is switched OFF, otherwise
the DCC player buttons will not operate.
1
.
Connect the (remote and the) in-ear phones to the
PHONES/REMOTE socket.
2. Open the cassette compartment with the OPEN
switch.
3. Insert a cassette and close the compartment.
4. Adjust the volume using the VOLUME control and
the bass sound using the DBB selector.
5. Start playback by pressing PLAY/SIDE ◄ ►.
As soon as playback starts, the display shows the
corresponding track number and the absolute elapsed time
(the time which has elapsed from the start of the tape
until the present playback position).
1
<fcc *5
Play
□
In case you are using a prerecorded DCC cassette, the
display will automatically show the track title after the
text information on the tape has been read.
1 PROLOGUE
P
cfcc
Side A and B of the cassette will be played back
continuously (up to a maximum of 12 cassette sides).
6. To stop playback, press STOP/OFF ■.
•The DCC player also stops:
-when the cassette compartment is opened.
- if the batteiy runs down or if the power supply is
interrupted in another way.
-when the player has played back 12 cassette sides of the
same cassette (when reverse mode CJ is selected).
• Open the cassette compartment only when the DCC player
Is In the STOP position.
• To switch off the DCC player immediately, press STOP/OFF
■ a second time.
• In the STOP position, the DCC player shuts down
automatically 3 minutes after the last command.
Remarks:
• If the battery has run down, the DCC player will not
function normally. For example, it will not start. Recharge
the battery or use the mains adapter.
PLAYING AN ANALOG CASSEHE_
• If you want to playback an analog cassette, follow the
instructions as described for DCC cassettes.
The player distinguishes metal/Cr02 tapes and normal
tapes automatically.
L.
Use the DOLBY NR selector to switch the Dolby Noise
Reduction System on or off.
As soon as playback starts, the display will show the tape
counter. The level meter will not be indicated on the
display._
Fwd 3104
Play
OPERATION FEEDBACK VIA HEADPHONES
When you are pressing a button or when the unit is
performing an operation, a beep tone will be heard to let you
know which operation is being performed:
Operation_Beep tone pattern
Side A (Fwd) starts recording/playback..
Side B (Rev) starts recording/playback...
Stop..
Power off.
Fast forward wind..
Fast rewind..
Next track search (during winding).
Previous track search (during winding) ■■
-=short high tone
-=short low tone
—=long low tone
11
Advertisement
