Advertisement
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the apparatus for repair
If you are unable to remedy a problem by following these hints, consult your dealer or service centre
WARNING
Under no circumstances should you try the apparatus yourself, as this would invalidate the guarantee
SYMPTOM
POSSIBLE CAUSE
REMEDY_
BOTH DCC AND ANALOG CASSEHES
No recharging
_- Mains adapter is not properly connected
• Connect the mains adapter properly
No operation
- The unit is still in the HOLD mode_• Switch the HOLD mode off_
- Mains adapter is not properly connected
• Connect the mains adapter properly
_- The rechargeable battery has run down_* Recharge the battery_
Intermittent playback sound
- The head section is dirty_• Clean the head section_
DCCCASSEHES
Distorted signal
-
Recording was made with too high peak
• Make a new recording with lower peak
_level (OVERLOAD)_level_
Track number or elapsed play -
The cassette has been loaded In the middle
• Rewind the tape to the start of the track
time is not displayed correctly
of one of the tracks_and start playback_
No track number indication
-
Recording has been started while track and
• You may consider to re-record the tape
_time information was not known_
ANALOG CASSEHES
Poor sound quality
_- Dolby NR has not been set correctly_* Set Dolby NR to the correct position
DISPLAY MESSAGES
Ho Text Info
■ T his indicates that the DCC tape does not contain text
information. The display will go back to showing the
previous information.
Press- Pl-ay-key!
o !
dec
a
n
. .
i
- TEXT information cannot be read when the player is in the
stop mode. Press the PLAY/SIDE ◄ ► key to start play¬
back.
20
Advertisement
