Yamaha PortaSound PSS-795 Owner's Manual page 45

Owner's Manual
Cannot turn ON the Vector Synthesizer.
is ON.
Because the Pad Assign function
Turn OFF the Pad Assign
function pressing the
corresponding button.
Because the VECTOR SYNTH
Track in Song Memory is ON.
Clear the VECTOR SYNTH
Track out.
Abnormally works or malfunctions.
Any unfamiliar status found.
Cannot control the PSS-795 any longer.
The PortaSound's internal micro-
computer may have been "locked up"
by Static Electricity or other factors.
Step 1: Turn the PortaSound OFF.
Step 2: Then press the SINGLE FINGER
and FINGERED buttons simultaneously and
hold them down, and turn the POWER ON.
This operation is called "All Reset", and
brings the PSS-795 to the status when
shipped. But remember this operation will
clear the whole data in the Song Memory.
Battery Change:
if you plays the PortaSound without cease, you may hear
the sounds distorted. This is why batteries' voltage is
lowered. If you go on using the PortaSound, «bt chn»
indication will be shown in the STYLE/VOICE display and
MULTI DISPLAY. In this case, change all of 6 batteries at a
time. Be sure not to use the different type(s) of batteries
together.
AA | Hi TÈ
БЕ &hn
"
Buffer Full:
While the PSS-795 is Receiving the MIDI performance
information from an external Master device, in case the
quantity of MIDI information is over that the PSS-795 can
process at a time, it will show <bu full> in the STYLE/
VOICE display and MULTI DISPLAY for a second.
Simultaneously, the notes currently sounding will
automatically stop. Should this occur, lessen the MIDI
information from the Master.
STYLE/VOICE
80
STE УЖЕ
MULTI DISPLAY
808
AUTO ACCOMP. BEAT
Channel Full:
While Transmitting or Receiving the MIDI performance
information, or even playing on the Keyboard, if the total
amount of notes on Channels 1 — 16 exceeds 28 (:
Maximum of sound reproduction), the STYLE/VOICE
display and MULTI DISPLAY will go on reading «Ch Full»
until the total amount of notes is reduced under 28.
Check Sum Error:
While the PSS-795 is Receiving the "System Exclusive
Message" (: the same data as the PSS-795 transmits in
Memory Bulk Dump; General name for this kind of data in
MIDI Standard), if the indication <Err> is shown in the
MULTI DISPLAY, this means the Receiver PSS-795 failed
to Receive the Exclusive data. In this case, specified
Factory Preset data corresponding to the Exclusive data
missed will be applied automatically.
MULTI DISPLAY
Memory Full:
While using the Song Memory function, if «Full» indication
is shown, this means the memory capacity of the Song
Memory has been reached. At this time, Recording will be
automatically stop and Bar indication in the SONG#/
MEASURE display turns to «001». If you wish to go on
Recording, you have to Clear the Recorded data by Track.
(See page 30 for Clear function.)
MULTI DISPLAY
Бан)