Table of Contents
Advertisement
Troubleshooting
If the Harmony effect does not seem to work as expected, check the following points:
• Is
Part
• Is the
• For Vocoder and Chordal types:
Is the
the MIDI keyboard or sequencer?
Are other keyboard/sequencer settings appropriate? (For example, check
that Note On messages are being properly sent, that all transpose and other
pitch related settings are at "0" or normal, etc.)
• Is
Harmony Mute
• Are the
If the parameter settings do not seem to change on the connected tone generator/sound
card when using the VH Effect Editor, check the following points:
• In host application, make sure that System Exclusive is NOT checked (System
Setup, MIDI Out Filter tab).
• Make sure that the tone generator is properly set to receive system exclusive
messages. (On the MU100, the Receive System Exclusive parameter in the
Utility mode should be set to "on.")
When using inserted VH Effect Editor data in a sequenced song, if the Harmony effect
doesn't work as expected or behave erratically, the tone generator/sound card (or host
application itself) could be "choking" on too much MIDI data. To remedy this, set
to a higher number and re-insert the data.
set to "Ad1" or "Ad2"?
Lead/Harmony Balance
Harmony Channel
set to "off"?
Harmony Volume (1 - 3)
set to an appropriate value (such as "L=H")?
set to the same channel as the transmit channel on
settings appropriate?
29
Interval
Advertisement
Table of Contents
