Yamaha MDF3 Owner's Manual page 28

4. Prepare the receiving device.
Prepare the receiving device to receive
the bulk data. The preparations to be
made vary from device to device. Refer
to the appropriate operation manual to
check the correct procedure.
28
5. Transmit the MDR data.
Press the START/STOP key to begin trans-
mitting. While the bulk data is being
transmitted, the LCD will display the
amount of data that has been sent.
Pfåsound~01-020k
file name block number
The file selection display will reappear
when the transmission of MDR data is
complete.
amount of
transmitted
Hint:
data
To stop transmission temporarily, press
the PAUSE key. The LED above the key will
blink, and the MDF3 will complete its trans-
mission of the current data block. Once the
block has been transmitted, the PAUSE key
LED will light steadily to indicate that the
MDF3 has paused. The MDF3 will resume
transmission when you press the PAUSE key
again or press the foot switch if it is con-
nected.
You can cancel transmission by pressing the
START/STOP key. The MDF3 will end trans-
mission after it has sent the current data block.