Yamaha MDF3 Owner's Manual page 25

4. Prepare the MDF3 for reception.
While pressing the REC key, press the
START/STOP key.
The LEDs above these keys will light, and
the following display will appear in the
LCD.
MDRå03~~~00-000k
default file current block total data received
name number (kilobytes)
This display indicates that the MDF3 is
ready to begin receiving block data.
5. Send the bulk data.
Execute the sending device's bulk dump
procedure to begin sending data. Refer
to the appropriate operation manual for
a description of the correct procedure.
As soon as the MDF3 begins receiving
data, the MIDI LED will light and the dis-
play will begin changing to indicate the
amount of data received.
MDRå03~~~01-001k
The MIDI LED will go out when all of
the bulk data has been received.
Hint:
To stop reception temporarily, press the
PAUSE key. The LED above the key will blink,
and the MDF3 will complete the reception
of the current data block. Once the block has
been received, the PAUSE key LED will light
steadily to indicate that the MDF3 has paused.
Pressing the PAUSE key again or pressing the
foot switch (if connected) will cause the
MDF3 to resume reception.
You can cancel reception immediately by
pressing the START/STOP key. If you do so,
the MDF3 will not create an MDR data file.
25