Setting Down, Transportation And Storage - Miele Complete C3 Score Red PowerLine Operating Instructions Manual

Cylinder vacuum cleaners
Table of Contents

Advertisement

Available languages

Available languages

en
Opening the air inlet valve
(Fig. 29 + 30)
(not on models with LEDs or radio con-
trols on the handle, or Eco Comfort
handles)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the va-
cuum cleaner.
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to man-
oeuvre.
During vacuuming
 When vacuuming, pull the cleaner be-
hind you on its wheels. You can stand
it upright for vacuuming stairs and
curtains etc.
Interrupting operation (Fig. 28)
(for models with radio controls on the
handle)
The vacuum cleaner can be paused for
short breaks whilst vacuuming.
 Press the Standby button  on the
handle.
The Standby button is designed
to pause the vacuum cleaner for
short periods of time whilst vacuum-
ing. Do not leave the vacuum cleaner
in Standby mode for long periods.
This can cause overheating and dam-
age.
An LED will indicate each time a button
is pressed on the handle.
At the end of the pause you can do one
of the following:
62
 Press the Standby button  again to
switch the vacuum cleaner back on at
the setting you were using before
pausing it.
 Press the + button to switch the va-
cuum cleaner back on using the
highest power setting.
 Press the - button to switch the va-
cuum cleaner back on using the low-
est power setting.
Illuminating the work area (Fig. 31)
(for models with the LED handle)
Your vacuum cleaner is equipped with
an LED on the handle to illuminate the
work area.
 Press the  button on the LED
handle.
The lighting will switch itself off auto-
matically after approx. 30 seconds.
Setting down, transportation
and storage
Park system for pauses during vacu-
uming (Fig. 32)
The Park system allows you to conveni-
ently park the suction tube and floor-
head during pauses.
 Slot the floorhead or floorbrush into
the parking attachment on the va-
cuum cleaner.
If your vacuum cleaner is on a sloping
surface, e.g. a ramp, retract the tele-
scopic tube fully.
Park system On/Off switch
Some models are fitted with an On/Off
switch in the park system.

Advertisement

Table of Contents
loading

Table of Contents