Table of Contents
Advertisement
STARTUP
4. START UP
4.1 SWITCHING THE UNIT ON
1. Switch the Fx 70 on via the POWER switch (10).
I_I
POWER
2. The unit is now in switched on status. The last
program (1-3) stored via STORE appears, the last
MIDI channel or MIDI OFF stored via STORE is
selected, parameter ROTOR BALANCE is selected,
Display (5) briefly indicates the software version
number (e.g. 2.0) and is then dark, Effect is switched
ON and the rotors are at a standstill (STOP).
3. The Fx 70 is subsequently ready for operation.
4.2 SETTING LEVELS
1. First adjust the setting of the INPUT selector switch
according to the equipment connected.
2. Whilst you are setting the level with the INPUT
control (1), constantly check the maximum indication
on the LEVEL DISPLAY (3). The optimum value is
0 dB. If the level range should be inadequate, press
the INPUT selector switch (at the rear) to HI/LO
position. The CLIP LED indicates internal overloading
and should not be lit up on any account.
□ CLP
□
0
□ -a
□ -a
WVT
LO:
This range is selected for low levels such as
guitar or bass guitar.
HI:
This range is selected for medium to high levels
such as AUX OUTPUT, audio equipment with
line level.
INPUT
□
RIGHT
L°
LEFT
4-1
Advertisement
Table of Contents
