Table of Contents
Advertisement
Service Presets Fx 70
Presets are selected via Index 00 (see service functions). Presets are called up using the rotary encoder and are
immediately valid without confirming with Enter. These presets can be edited and stored as usual (see 5.4 Storing
of programs in the Operating Manual).
SPEED
TREBLE
Number
1
Original Through (EQ linear)
2
Original Through only Right (EQ linear)
3
Original Through only Left (EQ linear)
4
Muted
5
Sine Output Left and Right
6
Sine Output only Right
7
Sine Output only Left
8
Frequency Response Bass and Trebles cut
9
Frequency Response Middle cut
10
Frequency Response Bass and Trebles boost
11
Frequency Response Bass and Trebles cut
12
Frequency Response Bands Pattern 1
13
Frequency Response Bands Pattern 2
14
Frequency Response all Bands fu lly cut
15
Frequency Response all Bands fully boosted
16
Original Through with Distortion 5
17
Original Through with Distortion 15
18
Level correction boosted individually
19
Level correction cut individually
20
Compensation in/out individually
21
Distorrtion in/out individually
22
Clean Leslie, only bass rotor, crossover minimum
23
Clean Leslie, only hom rotor, crossover minimum
24
Clean Leslie, only bass rotor, crossover maximum
25
Clean Leslie, only hom rotor, crossover maximum
Service Routines Fx 70
Service Routines are called up via Index 58 (see service functions). After pressing the "SPEED TREBLE" key a
service routine can be selected (see table below). The selected Service Routine starts after pressing the "STORE"
key.
SPEED
STORE
TREBLE
Number
Execution
0
NO CHANGE RETURN
1
SOFTWARE RESET
2
DISPLAY SOFTWARE VERSION
3
DISPLAY ROM CHECK SUM
Output of the 16 bit-wide additive 8 bit check sum of the EPROM 27256 (address range
8000h...FFFFh) as 2 successive Hex figures (MSByte, LSByte) in the seven-segment display.
50
Advertisement
Table of Contents
