Connect Inlet Hoses. Cceeceeessseeeeee W - Kenmore 27122310 Installation Instructions Manual

Hide thumbs Also See for 27122310:
Table of Contents

Advertisement

Available languages

Available languages

CONNECT INLET HOSES
Insert new hose washers (supplied) into each end of the inlet hoses.
| Connect Inlet Hoses to Washer
Firmly seat the washers in the couplings.
1. Attach cold water hose to cold water inlet valve marked with
a blue ring. Screw coupling by hand until it is snug.
Washer
Coupling
Connect Inlet Hoses to Water Faucets
1. Attach hose to hot water faucet. Screw on coupling until it is
seated on washer. Repeat process for cold water.
2. Attach hot water hose to hot water inlet valve marked with
a red ring. Screw coupling by hand until it is snug.
NOTE: Do not overtighten. Damage to the valve can result.
4. Turn on water faucets to check for leaks. A small amount
of water may enter washer. It will drain later.
IMPORTANT:
Do not overtighten or use tape or sealants on valve
when attaching to faucets or washer. Damage can result.
Clear Water Lines
@
Run water through both faucets and inlet hoses, into a laundry
tub, drainpipe, or bucket, to get rid of particles in the water
lines that might clog the inlet valve screens.
@
Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold water hose is connected to the cold water faucet.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates on
the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

2992310

Table of Contents