Grouping Output Channel Faders - Yamaha 02R96 Owner's Manual

126
Chapter 11—Common Channel Functions

Grouping Output Channel Faders

The Bus Out, Aux Send, and Stereo Out faders can be grouped, allowing you to control the
level of several Output Channels simultaneously. There are four Output Channel Fader
groups: Q, R, S, and T.
1 Use the DISPLAY ACCESS [GROUP] button to locate the Output Fader Group
page.
Press the LAYER [MASTER] button.
2
3 Use the Up/Down cursor buttons to select Fader groups Q–T.
The selected group is highlighted by a flashing cursor box.
4 Use the [SEL] buttons to add and remove Output Channel faders to and from
the selected group.
When an Output Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
OUTPUT FADER MASTER: When this check box is not checked, the Output Channel
fader positions determine the fader levels in the Output Channel Fader groups. When this
check box is checked, you can set the master level for the corresponding Output Channel
Fader group in the Master column. The resultant Output Channel level equals the corre-
sponding Output Channel fader level plus the Group master level. See "Group Master for
the Output Channel Faders" on page 127 for more information.
When the Output Fader Master check box is not checked, operating the channel faders will
affect the Output Channel levels in the corresponding Fader group. Pressing and holding
down the [SEL] button while operating the fader of an Output Channel will temporarily
cancel the corresponding Fader group, which is convenient if you want to adjust the relative
balance between channels.
When the Output Fader Master check box is not checked, fader groups are active only in
Fader mode. See "Selecting Fader Modes" on page 49 for more information.
02R96 Version 2—Owner's Manual