New Functions In 02R96 Version 2 - Yamaha 02R96 Owner's Manual

Aux Sends
You can exclude channels from Aux Sends (Mix Minus). → page 104
•
You can copy the channel fader positions to Aux Sends. → page 104
•
You can set all Send levels to nominal simultaneously. → page 99
•
• If an Aux Send is set to pre-fader, you can set the Pre point before or after the [ON] button.
→ page 99
Common Channel Functions
• Input and Output Channel Meter pages indicate the gain reduction being applied by the
Gate and Compressor. → page 108
• You can select whether the Input Channel's Pan setting is used when the Input Channel Solo
signal is set to Pre Fader. → page 121
Raising the channel faders for soloed Channels from – ∞ can unsolo the Channels.
•
→ page 121
• The AUX SELECT [AUX 1]–[AUX 8] buttons enable you to solo or unsolo Aux Sends.
→ page 121
• The Fader Group Master function enables you to control the overall level of the Fader group
channels simultaneously while maintaining the relative level balance of each channel.
→ page 127
• The Mute Group Master function enables you to mute all channels in a Mute group simul-
taneously. → page 129
Monitor
The level of the Surround Monitor can be reset to 85dB SPL. → page 138
•
• A new parameter has been added to Base Management on the Surround Monitor Setup
page. → page 140
• Surround Monitor is also available when Surround mode is set to Stereo.
• You can simultaneously select BUS and SLOT on the Surround Monitor page.
• You can select from Slot Channel 9 through Channel 16 as Surround Monitor signal sources.
• You can simultaneously select 2TRD, D2, D3, A1, or A2, and STEREO, ASSIGN1, or
ASSIGN2 as Control Monitor signal sources.
You can select the Talkback mic signal as the Studio Monitor source. → page 142
•
Internal Effects and Plug-ins
You can add optional Add-On Effects to the preset effects. → page 157
•
Scene Memory
You can globally apply the Fade Time setting to all scenes. → page 166
•
You can globally apply the Recall Safe setting to all scenes. → page 167
•
• Any channel or parameter settings in the current scene can be copied and pasted into other
scenes. → page 168
You can select more parameters for the Recall Safe function. → page 167
•
Automix
• You can insert the current mix parameters in a region specified in the Automix data.
→ page 180
• Touching the faders can punch parameter values in and out if the corresponding OVER-
WRITE button is set to on. → page 171
A parameter related to timecode synchronization has been added. → page 234
•

New Functions in 02R96 Version 2

02R96 Version 2—Owner's Manual
7