AEG TR73CB96 User Manual page 18

1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down Anti-crease button
by around 3 seconds.
The symbol appears on the display.
4. To deactivate the child lock, touch the
above button again until the symbol
disappears.
8.8 Starting a program
To start the program:
Touch the Start/Pause button.
The appliance starts and the LED above the
button stops flashing and stays on.
8.9 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn on
the appliance.
3. Set a new program.
8.10 Programme end
Clean the filter and drain the water
container after each drying cycle. (See
chapter CARE AND CLEANING.)
18 ENGLISH
If the drying cycle is finished, the symbol
appears on the display. If the End Signal
option is activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the
anti-crease phase starts (not active with
all programmes). Flashing
signals the execution of the anti-crease
phase. Laundry can be removed during
this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds to
turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
Adjustment of the target final
See chapter
moisture
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Leave the door slightly opened after
every cycle to avoid moisture.
symbol