Changing Front Panels - KitchenAid Superba Selectra KUDA22ST Use And Care Manual

Changing Front Panels
(FOR MODEL KUDA22ST ONLY)
Your new KitchenAid dishwasher comes with
a stainless steel trim kit and two reversible
front panels installed one behind the other.
You can choose from black or white (front
and back of one panel] and almond or harvest
wheat (front and back of the second panel).
If you want to change the color of the
panels, follow the instructions below:
Electrical Shock Hazard
Disconnect electrical power supply to
dishwasher before changing panels.
Failure to do so could result in
electrical shock or personal injury.
Upper Panel:
1. Disconnect electrical power supply.
2. Pull door open. Remove the two screws
{A} on each side of the dishwasher door
that secure the upper panel assembly.
3. Close door while holding upper panel in
place. Pull out lower edge of panel until
top edge of panel drops down.
4. Place panel on a smooth, flat surface and
remove three screws (B) from either side
of panel to remove the trim strip (C).
5. Slide the panel out. Handle carefully so
the panel will not be scratched or bent.
Turn the panel to the desired color. Place
the color panel in position then push the
filler panel in behind it.
23