Systems Monitor - KitchenAid Superba Selectra KUDA22ST Use And Care Manual

Systems Monitor
Letters, words, and numbers will appear in
the Systems Monitor to let you know what's
happening inside your dishwasher. The
Systems Monitor tells you. . .
RINSE WASH DRY "ce
— — RINSED = TIME
POTS/PANS ONLY rah
NORMAL HEATED PREHEATING
LIGHT/CHINA DRYOFF § § § 9 WATER oF
RINSE HOLD =pooR <<
OPEN DELAY WASH em
TEMPERATURE =
ee ew oe oo ani NERY
SANI
a= Gap ae ep
WARM HOT
1. Cycle Name
The Cycle Name appears after a cycle
selection pad is touched.
2. Cycle Time
The Cycle Time appears and counts down the
time remaining in the cycle after the START
pad is touched.
3. Cycle Phase
The Cycle Phase will appear after the START
pad is touched to let you know what portion
of the cycle is being performed, i.e., WASH,
RINSE and DRY.
4. Energy Savers
"HEATED DRY OFF", "PREHEATING WATER
OFF', and "DELAY WASH" Energy Savers
will appear if selected. Otherwise, 'HEATED
DRY" will be indicated with all Wash
Selections. 'PREHEATING WATER" will be
indicated with Pots/Pans and Normal cycles.
"DELAY WASH" can be used with any Wash
Selection. This permits the dishwasher to
cycle only during desired off peak hours.
5. Water Temperature Indicator
The Water Temperature Indicator will display
progress of the water temperature during
Preheating Water and Sani Rinse. The
temperature display bars will light from left
to right (WARM-HOT-SANI] as the water
temperature increases.
6. Energy Use Indicator
The Energy Use Indicator will display the
relative amount of energy used for any cycle
combination. The display bars will light from
left to right to indicate more or less energy
depending on the wash selection and
options chosen.
Other displays include:
Cancel
If the CANCEL pad is touched,
CA will appear.
Power Failure
If the power in the house or in
the dishwasher has gone off
for more than 5 seconds, PF
will appear. *
Door Open
If the door has been left open
during a cycle, DOOR OPEN
will appear.
Cycle Delay
If acycle delay has been
selected, the number of hours
will appear, for example "9H."
*This includes an open circuit breaker, a blown
fuse, or a loss of service from your local
utility. The PF will appear after Power has
been restored to the dishwasher and the
door is latched. To eliminate the PF, close and
latch door, then touch CANCEL. Check the
detergent dispenser and refill if empty.
Reselect your Wash Cycle, Special Options,
and Energy Saver Options, and then touch
the START pad.
Important: If the door is closed but not
latched, an "L" will appear.