Important Safety Instructions - Peavey XRD 680S Operating Manual

Powered mixer
Hide thumbs Also See for XRD 680S:
Table of Contents

Advertisement

IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using electric products. basic cautions should always be followed, including the following:
1. Веадай safety and operating instructions before using this product.
2. All safety and operating instructions should be retained for future reference,
2. Obey all cautions in the operating instructions and on the back of the unit.
structions should be followed.
4.
All operating
5.
This product should not be used near water, i:e., а bathtub, sink, swimming pool, wet basement, etc.
6. This product should be located so that its position does not interfere with i t s proper ventilation, It should not be placed flat against a
wall or placed in a built-in enclosure that will impede the flow of cooling air.
7.
This product should not be placed near а source of heat such as a stove, radiator. or another heat producing amplifier.
8. Connect only to а power supply of the type marked on the unit adjacent to the power supply cord.
formation on grounding, write for our free booklet "Shock
9. — Never break off the ground pin on the power supply cord. For mor
Hazard and Grounding."
10. Power supply cords should always be handled carefully. Never walk or place equipment on power supply cords, Periodically check
cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit
11. The power supply cord should be unplugged when the unit is to be unused tor long periods of time.
12, ПРВЕ product is to be mounted in an equipment rack, rear support should be provided.
13. Меш!
based household cleaner if necessary. Disconnect un
14. Care should be taken so that objects до no: fall and liquids are not spilled into tbe unit through the ventilation holes or any other
openings.
15, This unit should be checked by a qualified s e r v i c e
technician if:
The power supply cord or plug has been damaged.
b. Anything has fallen or been spilled into the unit
v, The unit does not operate correctly.
d. The unit hay been dropped or the ei
16. The user should not attempt to service this equipment. All service work should be done b;
arts can be cleaned with a damp rug. The vinyl covering used on some units can be cleaned with а damp rag or an ammonia-
from power supply before cleaning,
losure damaged.
jualified service technician
17, This product should be used only with a cart or stand that is recommended by Peavey
Electronics.
18, Exposure to extremely high noise levels
may cause a permanent hearing loss, Individuals vary considerably in susceptibility to noise
induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently Intense noise for a su
The U.S. Government's Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level
exposures
Duration Per Day In Hours
Sound Level JBA, Slow Response
8
90
6
92
4
95
3
97
2
100
Ша
102
1
105
12
110
114 oF Tess
15
According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss.
Ear plugs or protectors in the ear canals or over
the ears must be worn when operating this amplification system in order to preven
permanent hearing loss if exposure is in excess of the limits as set forth above. To ensure against potentially
dangerous exposure to high
sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such
this amplification system be protected by hearing protectors while this unit is in operation.
SAVE THESE INSTRUCTIONS!
ER
I
A
Peavey Electronics Corporation 711 A Street / Meridian, MS 39301 / U.S.A. / (601) 483-5365 / Fax 486-1278
©1993
590302043
Printed in U.S.A. 2/96

Advertisement

Table of Contents
loading

Table of Contents