Table of Contents
Advertisement
15 dB
15 dB
Tape:
Effects:
Maximum Output Level:
Main:
-
*18 dBV (8.0
V RMS)
Monitor:
+18 dBV (8.0 Y RMS)
Tape:
=
+18dBV (8.0 V RMS)
Effects:
=
+18 dBV (8.0 V RMS)
Nominal Headroom:
Main:
-
18 dB
Monitor:
18 dB
Таре:
18 dB
Effects:
=
18 dB
Output Impedance:
Main:
-
100 ohms
Monitor:
100 ohms
Tape:
-
10k ohms
Effects:
100 ohms
Output Noi:
Residual: -101 dBV
(Master Levcl Down)
Bus: -94 dBV
(Master Nominal, All Channel Levels Full CCW,
Effects Returns Down)
Nominal: -86 dBV
(All Controls Nominal, Low-Z Input Terminated
150 Ohms)
Aux Input Impedance:
120 kilohms
Aux Input Level:
Nom:
0dBV
Мах: 47 dBV
Min:
-1заву
Tape Input Level:
Nom:
44dBV
Max:
+11 dBV
Min:
-10dBV
DIGITAL EFFECTS PROCESSOR
Reverberation Settings:
32 reverb positions
1 bypass
setting
13 warm reverbs
13 bright reverbs
2 gated reverbs
2 reverse reverbs
Frequency Response:
20 Hz to 11 kHz
Quantization:
16-Bit Linear PCM
Signal-To-Noise R:
95 dB Minimum
Headroom:
648 @ Limit LED
Illumination
POWER AMP SECTION
(300 SC Module with DDT")
Frequency Response:
+0, -1 dB 10 Hz to 40 kHz € Rated Power
Rated Power:
150 watts RMS into 4 ohms, both channels driven.
100 watts RMS into 8 ohms, both channels driven.
Power (8 Clipping:
(1% THD, 1 kHz. 120 VAC line, typical)
160 waits RMS into 4 ohms,
each channel, both
channels driven.
113 watts RMS into 8 ohms, cach channel, both
channels driven,
225 waits RMS into 4 ohms, one channel driven.
130 watts RMS into 8 ohms, one channel driven
Intermodulation Distortion:
Less than 0.1%, (10 mW to rated power, 250 Hz & 7
kHz, 4 ohms)
Total Harmonic Distortion:
Less than 0.1%
DDT" Dynamic Range:
Greater than 26 dB
DDT" Maximum Distortion:
Below 0.5%
THD for 6 dB overload
Below 1% THD
for 20 dB overload
Hum & Noise:
-92 dB below 150 watts
Slew Raie:
15 V/uSec
1 V RMS For 150 watts @ 4 ohms
Input Impedance:
19 kilohms
Power Requirements:
800 watts, 120 V AC, 60 Hz
Advertisement
Table of Contents
