Digital Effects; Channel Fader - Peavey XR 800FPlus User Manual

26
27
28
29
30
31
32
33
34
26. GAIN:
With your Channel Fader (34) and the master faders (23) set to the
"0" position, adjust this control for desired volume through the
system. If the red LED lights, it is set too high.
27. HI EQ:
A shelving type of active tone control that varies the treble
frequency levels ±15 dB at 12 kHz. It is designed to remove noise
or to add brilliance to the signal, depending on the quality of the
source. (The high control can also be found on Channels 7
through 9.)
28. MID EQ:
Mid ±15 dB. This control sets the amount of cut or boost at the
mid-frequency (850 Hz). The mid control can also be found on
Channels 7 and 8.
29. LO EQ:
A shelving type of active tone control that varies the bass frequency
levels ±15 dB at 70 Hz. It will add depth to thin signals, or clean up
muddy ones. (The low control can also be found on Channels 7
through 9.)
30. MON:
Adjusts the level of the channel signal (pre-EQ) that is added to the
Monitor mix. (The Monitor control can also be found on Channels 7
through 9.) This control is independent of the Channel Fader
control (34).
31.

DIGITAL EFFECTS:

This control varies the level into the digital effects processor bus by
adjusting the signal level from the particular channel to the digital
processor. The channel Gain (26) control also affects this level. The
digital effects send is after the channel fader and is therefore
affected by the channel fader setting.
32. PAN:
Sets the channel's position in the L/R stereo field. In the stereo
Channels (7, 8 and 9) this control acts as a balance control
between the two separate inputs.
33. PEAK LED:
Indicates when the signal input is too strong and signal clipping is
present. A clipped signal may damage your speakers.
34.

CHANNEL FADER:

Sets the signal level sent to the Left and Right bus. (This feature
can also be found on Channels 7 through 9.)
10