Lincoln Electric Fleet 400 Service Manual page 21

LINCOLN ELECTRIC
REPLACEMENT PROCEDURE
1. Position the long case side panel onto the machine.
2. Using a 1/2" nutdriver, tighten the four bottom screws securing the long case side panel to the
machine.
3. Remove the fuel cap.
4. Carefully position the roof onto the machine.
5. Attach the cover seal, fuel cap and fuel trough to the machine.
6. Using a 1/2" nutdriver, attach the fourteen screws and flat washers securing the roof to the
machine.
7. Position the short side case panel onto the machine.
8. Using a 1/2" nutdriver, attach the six screws and flat washers securing the short side case panel to
the machine.
9. Using a 1/2" nutdriver, tighten the two bottom screws securing the short side case panel to the
machine.
10. Carefully position the door slide onto the machine.
11. Using a 1/2" nutdriver, attach the ten screws and flat washers securing the door slide rail to the
machine.
12. Position the door assembly into the door slide rail.
Figure F.1 – Roof, fuel cap, cover seal, door slide rail, door assembly, fuel trough and short case side
panel locations
Fleet™ 400 Service Manual
16