Table of Contents
Advertisement
=> Continued
Audio Section
Video Section
#Do not plug in the power cord until all connections have been
e Note that binding pin plug cords together with power cords
completed.
or placing them near a power transformer will resuit in the
Be sure to connect the left and right channels properly (left
introduction of hum
or other noise.
veo
LD player, CDV player, BS tuner, etc.
with left, right with right).
e
If hum or other noise is produced when the ground wire is
einsert the plugs securely. Incomplete connections will result
connected, disconnect it.
in the generation of noise.
@
Noise
or humming
may
be generated
if a connected
component
is used
independently
without
turning
the
power of the AVR-1000 on. If this happens, turn on the
power of the AVR-1000.
Turntable (MM cartridge)
Gor
ee
ee
a
NOTE:
The
receiver
cannot
be used
with MC cartridges directly. Use
a separate
head
amplifier
or
step-up transformer.
}
ANALOG
OUTPUT
ourpurs
CD player
L
Se
Ground wire
ye
{This receiver)
DAT (for recording and playback)
The AVR-1000 is equipped with VIDEO
AUX
jacks
on
the
front
panel
for
playback
of video
equipment.
This
permits video cam-corders with play-
or
back functions as well as other equip-
ment to be connected.
Tape deck
Cam corder
INPUTS
«OUTPUTS:
Advertisement
Table of Contents
