Table of Contents
Advertisement
As shown in the figure, lift the inmost
glass slightly in
'A'
direction. Then
remove the glass by pulling in
'B
1
direction.
Repeat this operation to remove the
second and third inner glass.
First step of reassembling the door is
to mount the second and third inner
glasses.
Chamfered corner of the glasses
should overlap the chamfer on the
plastic housing as shown.
Mounting order of the second and
third glasses is not important since
they are interchangeable.
While mounting the inmost glass, take
great care that the printed surface
faces the second glass.
It is important in mounting all inner
glasses to position the bottom corners
of glasses into bottom plastic housings
properly.
Push the plastic part against to the
frame until you hear the "click" noise.
Important
All glass must be reassembled
after cleaning.
Replacing the oven lamp
DANGER
Hot surfaces may cause burns!
Make sure that the appliance is
switched off and cooled down in
order to avoid the risk of an
electrical shock.
The oven lamp is a special heat-
resisting (T 300 °C) electric light bulb;
see Technical Data, page 5. Oven
lamps can be obtained from a good
local electrical store.
NOTICE
Position of lamp might vary from
diagram.
1. Switch off the appliance at the
mains.
2. Unscrew glass cover by turning
anti-clockwise.
3. Unscrew oven lamp by turning anti¬
clockwise and replace it with new
one.
4. Refit the glass cover.
31 | EN
Advertisement
Table of Contents
