Advertisement
Servicing
If, having followed these instructions
carefully, your machine fails to work
properly, contact your local Zanussi
Service Centre, giving the full model
number and date of purchase if the
appliance is under guarantee.
Details of your local Zanussi
Service Centre can be found by looking in
the White Pages phone book under
Zanussi.
Before you do that, though, it is worth
making a few simple checks yourself.
If the machine won't start...
Ensure that the «On/Off» button has
been pressed in. For the drying cycle
make sure that the required time has
been selected by means of the diying
selector dial.
Make sure that the door of the machine
is firmly shut.
Make sure that the appliance is properly
plugged in and that the socket switch (if
any) is in the «on» position.
Check that there is power at the socket
by plugging in an appliance you know to
be working — a small lamp, for example.
If this too fails to work, check the main
circuit fuses in your home's consumer unit
or main fusejpox.
If the machine won't fill...
Make sure that the supply hoses are not
kinked.
Make sure that all water taps are turned
on.
Check that there is sufficient water
pressure. A way tojcheck this is to place
a two gallon bucket under the water feed
pipe to the appliance and turn on the
tap(s). The bucket should fill in about one
minute.
If the machine won't drain or spin...
Unhook the drain hose from the drain
pipe or sink and hold the hose over a
bowl on the floor. The water should drain
by gravity into the bowl. If the bowl is
full, hook the hose back up and empty the
bowl. Repeat the procedure until the
water has drained from the machine.
Then check that the drain filter in the
machine is not clogged.
If the machine empties as it fills...
Make sure the end of the drain hose is
not less than 50cm (20in) above floor
level.
If the machine vibrates badly, or is too
noisy...
Check that the machine is absolutely
level.
Check that there is sufficient clearance
between the machine and nearby wall,
furniture, etc.
Check that all the internal packing, plastic
spacers and transit security bolts have
been removed as described at the start of
these instructions.
IN-GUARANTEE CUSTOMERS
SHOULD ENSURE THAT THE
ABOVE CHECKS HAVE BEEN
MADE AS THE ENGINEER WILL
MAKE A CHARGE IF THE FAULT
IS NOT A MECHANICAL OR
ELECTRICAL BREAKDOWN.
* Please note that proof of purchase is
required for any in-guarantee service calls.
31
Advertisement
